LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Impala LS >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Starter Motor Replacement (3.8L) >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Starter Motor (3.8L)
    GM461897Courtesy of GENERAL MOTORS CORP.
  1. Align the starter motor to the engine.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the starter bolts (1,2) finger tight until seated.

    Tighten:  Tighten the bolts to 43 N.m (32 lb ft).

  4. Fig 2: Removing/Installing Starter Motor Components (3.8L)
    GM337939Courtesy of GENERAL MOTORS CORP.
  5. Install the positive battery cable (7) and the solenoid BAT terminal nut (6) finger tight to the starter motor.

    Install the starter solenoid wire (4) and the starter solenoid S terminal nut (5) finger tight to the starter motor.

    Tighten: 

    • Tighten the solenoid BAT terminal nut (6) to 10 N.m (89 lb in).
    • Tighten the starter solenoid S terminal nut (5) to 2.3 N.m (20.5 lb in).

  6. Install the torque converter covers. Refer to Torque Converter Cover Replacement in Automatic Transaxle - 4T65-E.
  7. Install the lower air deflector. Refer to Radiator Air Baffle and Deflector Replacement - Lower in Engine Cooling.
  8. Lower the vehicle.
  9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .