Installation Procedure
- Align the starter motor to the engine.
- Install the starter motor bolts (1,2) finger tight until seated.
Tighten: Tighten the bolts to 43 N.m (32 lb ft).
- Install the positive battery cable (9) and the solenoid BAT terminal nut (8) finger tight to the starter motor.
Install the starter solenoid wire (6) and the starter solenoid S terminal nut (7) finger tight to the starter motor.
Tighten:
- Tighten the solenoid BAT terminal nut (8) to 10 N.m (89 lb in).
- Tighten the starter solenoid S terminal nut (7) to 2.3 N.m (20.5 lb in).
- Install the torque converter covers. Refer to Torque Converter Cover Replacement in Automatic Transaxle - 4T65-E.
- Install the lower air deflector. Refer to Radiator Air Baffle and Deflector Replacement - Lower in Engine Cooling.
- Lower the vehicle.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
NOTE:
Refer to Fastener Notice in Cautions and Notices.