LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> SSR >> Repair and Diagnosis >> External Pages >> Different car >> Section 686 (Engine Control System - 5.3L - Introduction) >> Repair Instructions >> Quick Connect Fitting(s) Service (Plastic Collar) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Blowing Dirt Out Of Fitting (Plastic Collar)
    GM155410Courtesy of GENERAL MOTORS CORP.
  1. Relieve the fuel system pressure before servicing any fuel system connection. Refer to Fuel Pressure Relief Procedure .
  2. CAUTION: Wear safety glasses when using compressed air in order to prevent eye injury.
  3. Using compressed air, blow any dirt out of the quick-connect fitting.
  4. Fig 2: Squeezing Quick Connect Fitting Release Tabs (Plastic Collar)
    GM12777Courtesy of GENERAL MOTORS CORP.
  5. Squeeze the plastic retainer release tabs.
  6. Fig 3: Pulling Connection Apart (Plastic Collar)
    GM12778Courtesy of GENERAL MOTORS CORP.
  7. Pull the connection apart.