LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Malibu Base >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Exhaust Manifold Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Removing Exhaust Manifold Pipe-To-Exhaust Manifold Nuts
    GM892169Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the exhaust manifold pipe-to-exhaust manifold nuts.
  3. NOTE: Do not over-flex or damage the flex decoupler joint when moving the flex decoupler joint from the normal mounting position. The flex decoupler joint will flex a maximum of six degrees which is equivalent to the pipes connected at the joint which move 1 inch for each foot length of pipe. A three foot pipe would move a maximum of three inches.
  4. Pull down on the exhaust manifold pipe just enough to free from the manifold studs and secure to the frame.
  5. Lower the vehicle.
  6. Fig 2: Removing Exhaust Manifold Heat Shield Bolts
    GM1238972Courtesy of GENERAL MOTORS CORP.
  7. Remove the exhaust manifold heat shield bolts.
  8. Remove the heat shield.
  9. Fig 3: Disconnecting Exhaust Manifold Heated Oxygen Sensor (HO2S) Electrical Connection
    GM895176Courtesy of GENERAL MOTORS CORP.
  10. Disconnect the exhaust manifold heated oxygen sensor (HO2S) electrical connection.
  11. Remove the HO2S from the manifold.
  12. Fig 4: Removing Exhaust Manifold Nuts
    GM1238974Courtesy of GENERAL MOTORS CORP.
  13. Remove the exhaust manifold nuts.
  14. Remove the exhaust manifold and discard the gasket.