LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Malibu Base >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Exhaust Manifold Replacement - Left >> Installation Procedure

Installation Procedure

    Fig 1: Installing A New Manifold Gasket On Cylinder Head
    GM1276998Courtesy of GENERAL MOTORS CORP.
  1. Install a new manifold gasket on the cylinder head.
  2. Install the exhaust manifold.
  3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the exhaust manifold nuts.

    Tighten:  Tighten the exhaust manifold nuts to 16 N.m (12 lb ft).

  5. Install the front catalyst assembly and gasket. Refer to Catalytic Converter Replacement (Bank 1)  or and Catalytic Converter Replacement (Bank 2)  .
  6. Install the crossover pipe and gaskets. Refer to Exhaust Crossover Pipe Replacement  .
  7. Fig 2: Installing Exhaust Manifold Heat Shield
    GM1239016Courtesy of GENERAL MOTORS CORP.
  8. Install the exhaust manifold heat shield.

    Tighten:  Tighten the exhaust manifold heat shield bolts to 18 N.m (12 lb ft).

  9. IMPORTANT: Whenever the oxygen sensor is removed, coat the threads with nickel-based anti-seize compound, such as GM P/N 5613695, or equivalent.
    Fig 3: Connecting HO2S Electrical Connector At Side Of Engine
    GM1239005Courtesy of GENERAL MOTORS CORP.
  10. Install the HO2S into the exhaust manifold using J 39194-B  .

    Tighten:  Tighten the oxygen sensor-to-exhaust manifold pipe to 41 N.m (30 lb ft).

  11. Connect the HO2S electrical connector at the side of engine. Assure the connector is fully retained away from the exhaust manifold and heat shield edges.
  12. Install the air intake tube. Refer to Air Cleaner Intake Duct Replacement in Engine Controls.