LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Exhaust Seal Replacement >> Installation Procedure

Installation Procedure

  1. Install a NEW exhaust seal.
  2. Raise the front of the catalytic converter.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the left and right exhaust manifold nuts.

    Tighten 

    Tighten the exhaust manifold nuts to 20 N.m (15 lb ft).

    Fig 1: Left & Right Exhaust Manifold Nuts
    G01971213Courtesy of GENERAL MOTORS CORP.
  4. Install the exhaust pipe hanger lower bolts.

    Tighten 

    Tighten the exhaust pipe hanger bolts to 50 N.m (37 lb ft).

    Fig 2: Exhaust Pipe Hanger Lower Bolts
    G01971214Courtesy of GENERAL MOTORS CORP.
  5. Install the exhaust pipe brace lower bolts.

    Tighten 

    Tighten the exhaust pipe brace bolts to 50 N.m (37 lb ft).

  6. Remove the adjustable jack stand.
  7. Lower the vehicle.
    Fig 3: Exhaust Pipe Brace Lower Bolts
    G01971215Courtesy of GENERAL MOTORS CORP.