LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> TrailBlazer RWD >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Catalytic Converter Replacement (4.2L Engine) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Exhaust Hanger
    GM1338721Courtesy of GENERAL MOTORS CORP.
  1. Install the exhaust hanger to the catalytic converter pipe.
  2. Install the catalytic converter pipe to the vehicle.
  3. Install the transmission mount. Refer to Transmission Mount Replacement (4.2L) in Automatic Transmission-4L60-E/4L65-E.
  4. Install the converter pipe to the muffler.
    Fig 2: Exhaust Pipe To Muffler Joint
    GM753687Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. IMPORTANT: The exhaust flange nuts must be tightened evenly to align the joint and prevent exhaust leaks.
  6. Hand thread both nuts evenly until they contact the exhaust flange.

    Tighten:  Tighten the nuts to 45 N.m (33 lb ft).

  7. IMPORTANT: Do NOT reuse the old exhaust seal. ALWAYS replace the exhaust seal to prevent exhaust leaks.
    Fig 3: View Of Catalytic Converter Pipe
    GM1338717Courtesy of GENERAL MOTORS CORP.
  8. Install the converter pipe to the exhaust manifold with a NEW exhaust seal.
  9. Hand thread the nuts evenly against the exhaust flange until the pipe is secure.

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

  10. Install the H2OS. Refer to INSTALLATION HEATED OXYGEN SENSOR POSITION 2 in Engine Controls - 4.2L.
  11. Lower the vehicle.