Diagnostic Procedures
- Perform diagnostic system check - engine controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM. After performing diagnostic system check - engine controls, go to next step.
- If cooling system is low on coolant, repair cooling system as necessary. If cooling system is not low on coolant, go to next step.
- Turn ignition off. Disconnect ECT sensor. Connect a 3-amp fused jumper wire between the signal circuit and the low reference circuit of the ECT sensor harness connector. Turn ignition on, with engine off. With a scan tool, observe the ECT sensor temperature. Does the scan tool indicate that the ECT sensor temperature is more than 280°F (138°C)? If yes, go to step 7. If no, go to next step.
- Turn ignition off. Connect a 3-amp fused jumper wire between the signal circuit of the ECT sensor harness connector and a known-good ground. Turn ignition on, with engine off. With a scan tool, observe the ECT sensor temperature. Does the scan tool indicate that the ECT sensor temperature is more than 280°F (138°C)? If yes, go to next step. If no, go to step 6.
- Test the ECT sensor low reference circuit for a high resistance or an open. Repair circuit as necessary. Did you find and correct the condition? If yes, go to step 10. If no, go to DIAGNOSTIC AIDS .
- Test the ECT sensor signal circuit for a high resistance or an open. Repair circuit as necessary. Did you find and correct the condition? If yes, go to step 10. If no, go to DIAGNOSTIC AIDS .
- Remove the ECT sensor. Suspend the ECT sensor and a thermometer in a pan of water. Place the pan on a burner or hot plate. Test the resistance of the ECT sensor through the specified range of 50-194°F (10-90°C). Does the resistance and temperature closely match the Temperature vs Resistance table? See TEMPERATURE VS RESISTANCE table. If yes, go to next step. If no, go to step 9.
- Reinstall ECT sensor. Diagnose thermostat in engine cooling system.
- Replace ECT sensor. After repairs, go to next step.
- Using scan tool, clear DTCs. Turn ignition off for 30 seconds. Start engine. Operate the vehicle within the Conditions for Running the DTC. See CONDITIONS FOR RUNNING DTC . Does the DTC run and pass? If yes, go to next step. If no, go to step 2.
- Using scan tool, observe stored information. Does scan tool display any DTCs that have not been diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.