Diagnostic Procedure
- Perform I/M system check. See INSPECTION/MAINTENANCE SYSTEM CHECK . After performing I/M system check, go to next step.
- Turn all accessories off. Start engine and allow to idle. Accelerate at part throttle to 45-55 MPH and maintain speed for 6 minutes or until I/M SYSTEM STATUS updates to YES. If vehicle is equipped with either a 5-or 6-speed manual transmission, operation in 4th or 5th gear respectively may be required, in order for test to run. Using scan tool, observe I/M SYSTEM STATUS. If HO2S/O2S SYSTEM STATUS updated to YES, go to step 5 . If HO2S/O2S SYSTEM STATUS did not update to YES, go to next step.
- Using scan tool, observe DTC information. If scan tool indicates any failed DTCs, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If scan tool does not indicate any failed DTCs, go to next step.
- Using scan tool, observe NOT RAN SINCE CODE CLEARED display to determine if DTCs P0133, P0140 and P1133 have run. For those DTCs that have not run, see CODE ENABLE CRITERIA in appropriate DTC. Operate vehicle to meet code enable criteria until DTC(s) runs. Using scan tool, observe I/M SYSTEM STATUS display. If EVAP SYSTEM STATUS updated to YES, go to next step. If EVAP SYSTEM STATUS did not update to YES, see DIAGNOSTIC AIDS .
- Using scan tool, check for DTCs. If scan tool indicates any DTCs are set, see DIAGNOSTIC TROUBLE CODE DEFINITIONS .