Diagnostic Aids
DTC P0130 or slow response is most likely caused by one of the following conditions:
- Fuel Pressure
System will go rich if fuel pressure is too high. PCM can compensate for some increase, however, if it gets too high, a DTC P0172 may set. - Leaking Injector
Leaking or malfunctioning injector can cause system to go rich. - Manifold Absolute Pressure (MAP) Sensor
An output that causes PCM to sense a higher than normal manifold pressure (low vacuum) can cause system to go rich. Disconnecting MAP sensor will allow PCM to set a fixed value for MAP sensor. Substitute a different MAP sensor if rich condition is gone while MAP sensor is disconnected. - Pressure Regulator
Test for a leaking fuel pressure regulator diaphragm by inspecting for presence of liquid fuel in vacuum line to fuel pressure regulator. - TP Sensor
An intermittent TP sensor output can cause system to go rich due to a false indication of engine accelerating. - O2S1 Contamination
Inspect O2S1 for silicone contamination from fuel or use of improper RTV sealant. O2S1 sensor may have a White powdery coating and result in a high but false voltage signal, indicating a rich exhaust condition. PCM will then reduce the amount of fuel delivered to the engine, causing a severe surge or driveability problem.