LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Blazer 2D Utility, 4WD, Part Time, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls Self-Diagnostics - 4.3L >> Diagnostic Tests >> DTC P0106: Manifold Absolute Pressure System Performance >> Circuit Description

Circuit Description

Manifold Absolute Pressure (MAP) sensor responds to changes in intake manifold pressure (vacuum). The pressure changes occur based on the engine load.

PCM supplies 5 volts to MAP sensor on the 5-volt reference circuit. PCM also provides ground on the low reference circuit. The MAP sensor provides a signal to PCM on the signal circuit which is relative to pressure changes in the manifold. PCM should detect a low signal voltage at a low MAP, such as during idle or deceleration. PCM should detect a high signal voltage at high MAP, such as ignition on, with engine off or at a Wide Open Throttle (WOT) condition.

Certain models will also use MAP sensor in order to determine the Barometric Pressure (BARO). This occurs when ignition switch is turned on, with engine off. The BARO reading may also be updated whenever engine is operated at WOT. The PCM monitors MAP sensor signal for voltage outside of the normal range.

PCM calculates a predicted value for the MAP sensor based on throttle position and engine speed. PCM then compares the predicted value to the actual MAP sensor signal. DTC will set if MAP sensor signal is not within the predicted range.