LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> Prizm Base, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls Self-Diagnostics - 1.8L >> Diagnostic Tests >> DTC P0136: Ho2S Circuit - Sensor 2 >> Diagnostic Procedures

Diagnostic Procedures

  1. Perform On-Board Diagnostic (OBD) system check. See ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM. After performing OBD system check, go to next step.
  2. Turn ignition on, with engine off. Using scan tool, clear DTC information. Using scan tool, place vehicle into check mode. Operate vehicle within freeze frame conditions. If DTC resets, go to next step. If DTC does not reset, see DIAGNOSTIC AIDS  .
  3. Disconnect HO2S-2 harness connector. Turn ignition on, with engine off. Set DVOM to DC volt scale. Connect DVOM positive lead to battery voltage. Connect negative lead to HO2S-2 input circuit at harness connector. See WIRING DIAGRAMS article. Using scan tool, monitor HO2S-2 parameter. If scan tool voltage is about 1155 millivolts, go to next step. If scan tool voltage is not about 1155 millivolts, go to step  5 .
  4. Using test light connected to battery voltage, probe HO2S-2 ground circuit at harness connector. See WIRING DIAGRAMS article. If test light illuminates, go to step  7 . If test light does not illuminate, go to step  6 .
  5. Check for an open or short in HO2S-2 input circuit between HO2S-2 and PCM. Repair as necessary. After repairs, go to step  9 . If circuit is okay, go to step  8 .
  6. Repair open in HO2S-2 ground circuit between HO2S-2 and ground connection. Repair as necessary. After repairs, go to step  9 . If circuit is okay, go to step  8 .
  7. Replace HO2S-2. After replacing sensor, go to step  9 .
  8. Replace PCM. Program replacement PCM using required equipment. After replacing PCM, go to next step.
  9. After repairs, using scan tool, clear DTC information. Road test vehicle within freeze frame conditions that set DTC. Check for DTCs. If no DTCs are stored, repair is complete. If any DTCs are stored, diagnose affected DTC(s).