LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1999 >> Metro Base, 4D Sedan >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Diagnosis & Testing >> Diagnostic System Check >> Diagnostic System Check

Diagnostic System Check

  1. Turn ignition on. Install scan tool. If scan tool is not receiving data from EBCM, go to next step. If scan tool does receive data from EBCM, go to step 3)  .
  2. Check if scan tool is communicating with other modules on serial data line. If scan tool is communicating, go to TEST F. If scan tool is not communicating, problem is in data link connector circuit. See appropriate diagram in DATA LINK CONNECTORS article in WIRING DIAGRAMS.
  3. Check for stored DTCs. Check for DTC history. If DTCs are found, go to appropriate DTC test. If no DTCs are found, go to next step.
  4. Turn ignition off, then on, If ABS indicator comes on for several seconds and then goes off, go to step 6)  . If indicator does not come on and then go off, go to next step.
  5. If ABS indicator comes on and stays on, go to TEST A  under SYMPTOM TESTS. If indicator does not come on and stay on, go to TEST B  under SYMPTOM TESTS.
  6. Recheck for historical DTCs. If any DTCs are present, go to next step. If no DTCs are set, system is operating normally.
  7. Drive vehicle above 15 MPH for several minutes while checking for DTCs. If historical DTC is also set as a current DTC, go to appropriate DTC test. If DTC is not set as current, system is operating normally.
ABS SYMPTOM DIAGNOSIS (1)

Symptom Test
ABS Amber Indicator On Constantly, No DTCs Stored A 
ABS Amber Indicator Inoperative, No DTCs Stored B 
ABS ACTIVE Blue Indicator On Constantly, No DTCs Stored C 
ABS ACTIVE Blue Indicator Inoperative, No DTCs Stored D 
TECH 1 Displays Undefined DTCs E 
No Communication With EBCM F 
(1) Prior to proceeding to charts, perform DIAGNOSTIC SYSTEM CHECK .