LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1999 >> Cutaway 6.5 F >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System >> Programming >> PASSLOCK™ Seed & Key >> Seed & Key Procedure

Seed & Key Procedure

NOTE: Erase the Passlock™ related diagnostic trouble codes (DTCs) that are stored in the VCM/PCM. Record any DTCs. If any DTCs exist for 4.3L, 5.0l, 5.7L, 6.5L and 7.4L engines, refer to ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM in SELF-DIAGNOSTICS INTRODUCTION - GASOLINE - EXCEPT METRO, PRIZM & TRACKER article.
NOTE: In addition to the time involved in performing the specific steps, the Seed and Key procedure accomplishes the same task in 10 minutes as the Auto Learn procedure does in 30 minutes. Use either one of these 2 procedures.
  1. Ensure the ignition key is in the ON position.
  2. Ensure all Passlock™ module and VCM/PCM DTCs have been cleared.
  3. With the scan tool (TECH 2) connected to the vehicle, select Programming/Request Info from menu, then follow instructions.
  4. Disconnect scan tool from vehicle and perform Service Programming System/VTD Learn with Techline terminal, then follow instructions.
  5. Reconnect scan tool to the vehicle.
  6. Follow instructions on the scan tool to perform the VTD password learn on the vehicle, this takes about 10 minutes.
  7. After 10 minutes, the SECURITY indicator will turn OFF. The new security code is ready to be communicated among the Passlock™ module and VCM/PCM. The new Password is learned on the next ignition lock cylinder cycle from OFF to CRANK to ON (start attempt).