LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Metro Base >> Repair and Diagnosis >> Suspension >> Wheel Alignment Specifications & Adjustment Procedures >> Ride Height Adjustment >> Checking Procedure >> "N" Body

"N" Body

  1. Lift front bumper about 1.5" (38 mm) and allow vehicle to settle. Repeat 2 more times. Distance "A" is from center of front axle to locate point to measure dimension "J". Dimension "J" is measured from floor to bottom of rocker panel. Measure dimension "Z". Dimension "Z" is measured from bottom of ball joint to bottom of frame rail. See Figure. See RIDE HEIGHT SPECIFICATION ("N" BODY)  table. Note measurements. Do this 2-3 times, and average measurements.
  2. Lift rear bumper up about 1.5" (38 mm) and allow vehicle settle. Repeat 2 more times. Distance "B" from center of rear axle to locate point to measure dimension "K". Dimension "K" is measured from floor to bottom of rocker panel. See Figure. See RIDE HEIGHT SPECIFICATION ("N" BODY)  table. Push rear bumper down about 1.5" (38 mm) and allow vehicle to rise. Repeat 2 more times. Measure dimension "K" again. Average high and low measurements to determine true ride height.