EEPROM Reprogramming
NOTE:
Ignition switch should always be off when removing or installing VCM connectors.
Perform the following steps in order to set up EEPROM PROGRAMMING.
- Ensure battery is fully charged.
- Turn ignition switch to ON position.
- Ensure battery and cigarette lighter connection is secure.
- Connect scan tool to DLC. Refer to scan tool manufacturer's instructions to precede with reprogramming.
If VCM fails to reprogram, check all VCM connections for proper connection. Check scan tool equipment for latest software version. Retry reprogramming steps. If VCM will not reprogram, replace VCM. Using scan tool, perform IAC valve reset procedure. For a functional check, perform ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK .