LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1995 >> Tahoe 4D Utility, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (Engine Controls - Remove/Install/Overhaul - 7.4L) >> Powertrain Control Module (Pcm) >> Programmable Read-Only Memory (Prom) >> Removal

Programmable Read-Only Memory (Prom): Removal

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 1995 GMC Vandura Special, 1995 GMC Vandura, 1995 GMC Suburban, 1995 GMC Rally Camper Special, and 1995 GMC Rally. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove PCM from vehicle. See REMOVAL under CONTROL MODULE . Position PCM so bottom cover is facing upward. Remove slide-off PROM access cover by depressing locking tab.
  2. Using PROM removal tool, grasp PROM at narrow ends. Gently rock PROM from end to end while pulling up. If installing new PROM, remove old PROM from PROM carrier.
NOTE: Note reference notch locations in PROM, carrier and PCM for reassembly reference.