LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1995 >> Tahoe 4D Utility, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (Engine Controls - Remove/Install/Overhaul - 7.4L) >> Powertrain Control Module (Pcm) >> Mem-Cal >> Installation

Powertrain Control Module (Pcm): Mem-Cal: Installation

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 1995 GMC Vandura Special, 1995 GMC Vandura, 1995 GMC Suburban, 1995 GMC Rally Camper Special, and 1995 GMC Rally. However, it is still accessible from the selected car via links, so may be relevant.
  1. Carefully align MEM-CAL pins with PCM pin holes. DO NOT press in middle of MEM-CAL. Push downward evenly on ends of MEM-CAL until retaining clips on ends of MEM-CAL snap into place.
  2. Install PCM. Reconnect negative battery cable. Turn ignition on and ground DLC terminal "B". DTC 12 should be flashed at least 4 times. If DTC 12 is not flashed at least 4 times, other codes are present. If DTC 51 is present, or if MIL stays on constantly with code(s) present, MEM-CAL is not fully seated, or is defective.