LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1995 >> Monte Carlo Z34 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests - 3.1L >> Miscellaneous Controls >> Transmission (C-8) >> Converter Lock-Up Signal From PCM

Converter Lock-Up Signal From PCM

  1. Warm engine to operating temperature. Raise vehicle and support drive wheels. Support suspension where necessary to prevent damage to drive axles.
  2. Connect a test light to battery voltage. Touch TCC control driver terminal with test light. On some vehicles, this is terminal "F" of Data Link Connector (DLC). See Fig 1 - Figure . Accelerate vehicle to 45 MPH and note test light. If test light does not illuminate, problem is a faulty PCM connector or PCM.
Fig 1: Converter Clutch Schematic (3.1L With 3T40 Transaxle)
G94C32252Courtesy of GENERAL MOTORS CORP.
Fig 2: Converter Clutch Schematic (3.1L With 4T60 Transaxle)
G94D32253Courtesy of GENERAL MOTORS CORP.