LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1995 >> Beretta Z26 >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Diagnostic Charts >> Code 46 - Rear Channel Will Not Move >> Notes

Code 46 - Rear Channel Will Not Move: Notes

Detects bound-up Expansion Spring Brake (ESB), a stuck ABS motor or a seized hydraulic modulator. When ESB release is commanded by EBCM during initialization, ESB should release ABS motor, resulting in sensed current being less than commanded current (motor free-spinning). If ABS motor is not moving, sensed current will be equal to stall current.

Code 46 can set during normal operation and EBCM detects a condition in which it cannot move ABS motor in either direction. Code will be stored, ABS will be disabled and ABS warning light illuminated.

NOTE: Test numbers refer to numbers on diagnostic chart. Use only 10-megohm (minimum) DVOM for all voltage and resistance tests.
  1. Checks if motor terminals are in proper connector cavities.
  2. Checks for proper motor movement during apply and release command from Tech 1 scan tester.
  3. Compares command and feedback current during apply.
  4. Checks for short between ABS motor high and low circuit.
  5. Checks if ABS motor can apply properly under load.
  6. Determines if malfunction is due to poor terminal contact or EBCM.
  7. Checks for shorted ABS motor.
  8. Checks for proper hydraulic modulator gear and piston movement.