LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1995 >> Beretta Z26 >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Diagnostic Charts >> Code 25/26 - Excessive Wheel Speed Variation >> Notes

Code 25/26 - Excessive Wheel Speed Variation: Notes

As toothed ring passes wheel speed sensor, changes in magnetic field causes wheel speed sensor to produce an AC voltage signal whose frequency is proportional to wheel speed. The magnitude of the signal is directly related to wheel speed and proximity of wheel speed sensor to toothed ring, referred to as air gap. EBCM uses this signal to compare individual wheel speed data and to detect wheel lock-up.

Code can set when brake is off. This test detects a situation in which wheel acceleration or deceleration is beyond specified limits. Code will be stored, ABS will be disabled and ABS warning light will be illuminated.

NOTE: Test numbers refer to numbers on diagnostic chart. Use only 10-megohm (minimum) DVOM for all voltage and resistance tests.
  1. Identifies a wheel speed sensor for apparent physical damage that may cause code to set.
  2. Checks wheel speed sensor resistance.
  3. Verifies that wheel speed sensor can generate proper output signal.
  4. Ensures wheel speed sensor circuit is not shorted.
  5. Checks for proper voltages at wheel speed sensor harness connector.
  6. Ensures wheel speed sensor circuit is not shorted to ground.
  7. Checks for open in wheel speed signal low circuit.
  8. Checks for open in wheel speed signal high circuit.
  9. Ensures code was not set due to poor EBCM connection or physical damage to circuit.
  10. Checks for short to battery voltage in either the high or low wheel signal circuits.
  11. Ensures short to battery voltage was not due to physical damage of circuit.
  12. Tests for short to battery voltage between wheel signal high and low circuits.
  13. Ensure malfunction was not due to poor connection to wheel speed sensor or physical damage to circuit.