LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1994 >> Forward Control 7.4 N >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> A/C-Heater System - Manual >> Testing >> A/C Compressor >> A/C Compressor Does Not Operate

A/C Compressor Does Not Operate

  1. Turn ignition switch to RUN position. Place blower switch in HI position. Ensure A/C is on. If blower motor runs, go to step 3). If blower motor does not run, go to next step.
  2. Connect test light from Brown wire at blower switch connector to ground. If test light glows, go to next step. If test light does not glow, repair open Brown wire between blower switch connector and fuse block.
  3. Connect test light from Brown/White wire at mode selector control connector to ground. If test light glows, go to next step. If test light does not glow, check for open Brown/White wire between mode selector control connector and blower switch connector. If wire is okay, replace blower switch.
  4. Connect test light from Light Green wire at evaporator pressure control switch (located on A/C accumulator) to ground. If test light glows, go to step 5) on 7.4L or step 7) on all models except 7.4L. If test light does not glow, check for open Light Green wire between evaporator pressure control switch connector and mode selector control connector. If wire is okay, replace mode selector control.
  5. Connect test light from Dark Green wire at high pressure cut-off switch connector (located on rear of A/C compressor) to ground. If test light glows, go to next step. If test light does not glow, check for open Dark Green wire between high pressure cut-off switch connector and evaporator pressure control switch connector. If wire is okay, replace evaporator pressure control switch.
  6. Connect test light from Dark Green wire at coolant temperature cut-off switch connector (located on left side of engine, on cylinder head) to ground. If test light glows, go to next step. If test light does not glow, check for open Dark Green wire between coolant temperature cut-off switch connector and high pressure cut-off switch connector. If wire is okay, replace high pressure cut-off switch.
  7. Connect test light from Dark Green wire at A/C compressor connector to ground. If test light glows, go to step 10). If test light does not glow, go to step 9) on 7.4L or step 8) on all models except 7.4L.
  8. On all models except 7.4L, check for open Dark Green wire between A/C compressor connector and evaporator pressure control switch connector. If wire is okay, replace evaporator pressure control switch.
  9. On 7.4L, check for open Dark Green wire between A/C compressor connector and coolant temperature cut-off switch connector. If wire is okay, replace coolant temperature cut-off switch.
  10. Connect test light from Dark Green wire to Black wire at A/C compressor connector. If test light glows, replace A/C compressor. If test light does not glow, repair open Black wire between A/C compressor and ground.