LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1987 >> Chevette 2D Hatchback, Automatic >> Repair and Diagnosis >> Transmission >> Clutches >> Removal & Installation >> Clutch >> Installation

Removal & Installation: Clutch: Installation

  1. Install new pilot bearing using Pilot Bearing Installer (J-1552). See Figure . Once pilot bearing is installed, lubricate with several drops of light oil.
  2. Install clutch disc on pressure plate with damper springs offset toward pressure plate. Flywheel side is stamped "Flywheel Side". Install Clutch Alignment Shaft (J-33169 or J-5824) through pressure plate and clutch disc.
  3. Install assembly while aligning marks made during disassembly. Install attaching bolts finger tight. Check that the clutch alignment shaft is engaged into the pilot bearing. Alternately and evenly tighten bolts. See TORQUE SPECIFICATIONS  table at end of article.
  4. Remove clutch aligning tool. Lubricate ball stud and release fork with graphite grease and install release fork. Ensure release fork retaining spring is tight on ball stud.
  5. Lubricate recess on inside of throw-out bearing and lightly coat release fork groove and ball stud depression with graphite grease. Install throw-out bearing assembly.
  6. Place transmission in gear. While installing transmission, it may be necessary to rotate output shaft in order to align transmission input shaft with clutch disc splines. Once transmission is engaged with clutch splines, ensure that transmission input shaft is seated in the pilot bearing.
  7. Install retaining bolts. Install dust cover, crossmember and exhaust system. Connect speedometer cable and electrical connections. Install drive shaft. Check that alignment marks are aligned on drive shaft and companion flange.
  8. Install shift lever and retaining bolts, ensuring that control lever has engaged with shifter shaft lever. Install foam insulator, boot and floor console.
  9. Adjust ball stud location and clutch pedal free play. See ADJUSTMENT in this article. Check transmission fluid level if lubricant was lost during removal and installation. Install negative battery cable.