LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1984 >> Chevette CS, 2D Hatchback, 1.8 D, Standard >> Repair and Diagnosis >> Transmission >> Clutches >> Adjustment >> Ball Stud

Ball Stud

  1. Place gauge (J-28449) so flat end is against front face of clutch housing and hooked end is aligned with bottom depression in clutch fork. See Fig 2 .
  2. Turn ball stud clockwise by hand until release bearing makes contact with clutch spring and fork is snug on gauge.
  3. Install lock nut and tighten, being careful not to change ball stud adjustment. Remove gauge by pulling outward at housing end.
Fig 1: Exploded View of Rear Wheel Drive Clutch Assembly
G26006
Fig 2: Ball Stud Adjustment "T" Body
G26095