LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1984 >> Chevette CS, 2D Hatchback, 1.8 D, Standard >> Repair and Diagnosis >> Steering >> Steering Gear - Manual >> Overhaul >> Reassembly

Steering Gear - Manual: Overhaul: Reassembly

  1. Install rack gear with teeth facing pinion bore. Flat side of rack gear should be parallel with pinion shaft. Position rack gear so that teeth extend proper distance. See Fig 1.
    NOTE: Rack must be centered as described.
  2. Insert pinion gear into housing with flat side of input shaft oriented as shown in Fig. Fig 1. Tap pinion into housing until seated. Reset rack gear to proper position. If flat side of input shaft is more than 30° away from finished position shown, remove pinion and restart procedure.
  3. Install pinion retaining ring. Beveled edge of ring should face upward. Liberally coat top of pinion bearing with anhydrous calcium grease. Seat pinion seal flush with housing. Coat rack bearing with lithium grease and install.
    Fig 1: Pinion Gear Installation Position. If flat side of pinion is more than 30° from finished position, remove pinion, rotate 1 tooth and reinstall.
    G27125
  4. Coat both ends of preload spring and threads of adjuster plug with lithium grease. Assemble spring and plug into housing. Turn adjuster plug clockwise until it bottoms, then back off 50-60°. Torque required to turn pinion should be 6-16 INCH Lbs. (.7-1.8 N.m). Turn adjuster plug in or out to adjust preload as required. Tighten plug lock nut.
  5. Lubricate both ends of rack and rack teeth with lithium grease. Move rack back and forth several times by turning pinion shaft, adding grease to rack teeth each time. Install inner tie rod assemblies on rack as previously described, using a wood block or vise for support while staking.
  6. Position 1 large boot clamp on housing and place boot lip into position in undercut. Position clamp over boot at undercut and secure. Slip other end of boot into tie rod undercut, but do not tighten clamp until toe-in adjustment is complete. Repeat procedure for other boot and ensure that boots are not twisted.
  7. Thread jam nuts onto both tie rods and then thread on tie rod ends. Align and install flexible coupling onto input shaft. Install pinch bolt, but do not tighten. Reinstall gear in vehicle as previously described.