LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> CTS Base, AWD >> Repair and Diagnosis >> Body & Frame >> Mirrors >> Mirror System >> Diagnostic Information and Procedures >> Rearview Camera Full Display Mirror Malfunction >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF and all vehicle systems OFF, disconnect the X1 harness connector at the A10 Inside Rearview Mirror. It may take up to 2 minutes for all vehicle systems to power down.
  2. Test for less than 10 Ω between the ground circuit terminal 5 and ground.
    • If 10 Ω or greater 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, repair the open/high resistance in the ground connection.
    • Go to next step: If less than 10 Ω 
  3. Ignition ON.
  4. Verify a test lamp illuminates between the ignition circuit terminal 2 and ground.
    • If the test lamp does not illuminate and the circuit fuse is good 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ignition circuit end to end.
    • If the test lamp does not illuminate and the circuit fuse is open 
    1. Ignition OFF, disconnect the X50A Fuse Block - Underhood.
    2. Test for infinite resistance between the ignition circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the X50A Fuse Block - Underhood.
    • Go to next step: If the test lamp illuminates 
  5. Connect a test lamp between control circuit terminal 1 and ground.
  6. Verify the test lamp turns ON and OFF when commanding the Backup Lamps ON and OFF with a scan tool.
    • Go to next step: If the test lamp turns ON and OFF 
  7. Ignition OFF/vehicle OFF, disconnect the coax cable connector at the B87 Rearview Camera.
  8. Ignition On, test for 7 - 10 V between the center conductor of the coax cable and the coax cable ground shield wires.
    • If the value within the range of 7 - 10 V 

      Replace the B87 Rearview Camera.

    • Go to next step: If the value outside range of 7 - 10 V 
  9. Disconnect the A10 Inside Rearview Mirror, and check the coaxial cable resistance
    • If the value is more than 5 Ω 

      Replace the coax cable.

    • Go to next step: If the value is less than 5 Ω 
  10. Test or replace the A10 Inside Rearview Mirror.