LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> CT6 Plug-In >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Stabilizer Shaft Replacement (RWD) >> Installation Procedure

Installation Procedure

  1. Lightly apply lubricant to the front stabilizer shaft bushings. Adhesives, Fluids, Lubricants, and Sealers 
  2. GM4248227Courtesy of GENERAL MOTORS COMPANY

    Position the front stabilizer shaft (1) on the vehicle.

  3. GM4248226Courtesy of GENERAL MOTORS COMPANY

    Front Stabilizer Shaft Insulator Retainer (2) - Install [2x]

  4. CAUTION:

    Refer to Fastener Caution .

    CAUTION:

    This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

  5. Front Stabilizer Shaft Insulator Clamp Bolt (1) - Install NEW and tighten [4x]
    1. First Pass: 58 N.m (43 lb ft)
    2. Final Pass: (15 - 30 degrees)
  6. GM4248225Courtesy of GENERAL MOTORS COMPANY

    Front Stabilizer Shaft Link (1) @ Front Stabilizer Shaft - Install [2x] - Stabilizer Shaft Link Replacement (RWD) 

  7. GM4248224Courtesy of GENERAL MOTORS COMPANY

    Underbody Front Air Deflector (1) - Install - Underbody Front Air Deflector Replacement

  8. Install the front tire and wheel assemblies. Tire and Wheel Removal and Installation
  9. Remove the support and lower the vehicle.