Installation Procedure
- Install the rack and pinion outer tie rod end to the steering linkage inner tie rod. Do not tighten the steering linkage inner tie rod nut at this time.
- Connect the rack and pinion outer tie rod end to the steering knuckle.
- Install the rack and pinion outer tie rod end nut and tighten to 55 N.m (41 lb ft).
- Tighten the steering linkage inner tie rod nut (1).
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Adjust the front toe. Refer to Front Toe Adjustment .
NOTE:
Install the same number of complete turns the rack and pinion outer tie rod end needed to remove as noted above.
CAUTION:
Refer to Fastener Caution
.