LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> XLR V >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 4.4L - Introduction >> Repair Instructions >> Supercharger Inlet Duct Assembly Replacement >> Removal Procedure

Removal Procedure

    IMPORTANT: The front section of the supercharger inlet duct assembly can be serviced independently of the rear section.
  1. The supercharger must be removed to remove the rear section of the supercharger inlet duct assembly.
  2. Fig 1: View Of Air Cleaner Outlet Duct
    GM1685817Courtesy of GENERAL MOTORS CORP.
  3. Remove the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
  4. Remove the air cleaner outlet duct (1). Refer to Air Cleaner Outlet Duct Replacement .
  5. Fig 2: Identifying PCV Hose Fitting
    GM1685833Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: There is a positive crankcase ventilation (PCV) hose fitting on the underside of the supercharger inlet duct.
  6. Disconnect the (PCV) hose fitting (1) from the underside of the inlet duct assembly.
  7. Fig 3: Identifying Ball Studs
    GM1685839Courtesy of GENERAL MOTORS CORP.
  8. Loosen the rear screw clamps (2) located between the front and rear section of the inlet duct assembly.
  9. Remove all the ball studs (1) that retain the inlet duct to the supercharger. There are a total of 6 ball studs.
  10. Remove the front section of the supercharger inlet duct.
  11. Fig 4: View Of Supercharger Service Holding Tool Fixture
    GM1685842Courtesy of GENERAL MOTORS CORP.
  12. Remove the hood assembly. Refer to Hood Replacement .
  13. Remove supercharger assembly. Refer to Supercharger Replacement .
  14. Fig 5: View Of Rear Section Of Supercharger Inlet Duct Assembly
    GM1685836Courtesy of GENERAL MOTORS CORP.
  15. Loosen the rear screw clamps on the inlet duct seal.
  16. Remove the rear section of the supercharger inlet duct from the supercharger.