LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> XLR V >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 4.4L - Introduction >> Repair Instructions >> Intake Air Duct Seal Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Rear Section Of Supercharger Inlet Duct Assembly
    GM1685836Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the supercharger inlet duct seal and clamp to the throttle body.

    Tighten the supercharger inlet duct seal screw clamp.

    Tighten:  Tighten the supercharger inlet duct seal screw clamp to 2.5N.m (20 lb in).

  2. Install the rear section of the supercharger inlet duct assembly to the supercharger. Refer to Supercharger Inlet Duct Assembly Replacement .

    Tighten:  Tighten the supercharger inlet duct seal screw clamp to 2.5N.m (20 lb in).

  3. Fig 2: View Of Supercharger Service Holding Tool Fixture
    GM1685842Courtesy of GENERAL MOTORS CORP.
  4. Install the supercharger assembly. Refer to Supercharger Replacement .
  5. Fig 3: Identifying Ball Studs
    GM1685839Courtesy of GENERAL MOTORS CORP.
  6. Install the supercharger inlet duct seals and clamps (2) to the front section of the supercharger inlet duct.
  7. Tighten the screw clamps on the supercharger inlet duct seals.

    Tighten:  Tighten the supercharger inlet duct seal screw clamps to 2.5N.m (20 lb in).

  8. Install the front section of the supercharger inlet duct. Refer to Supercharger Inlet Duct Assembly Replacement .