LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> XLR V >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 4.4L - Introduction >> Repair Instructions >> Ignition Coil Replacement - Bank 2

Ignition Coil Replacement - Bank 2

Fig 1: View Of Ignition Coil - Bank 2
GM1655591Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the oil level indicator.
  2. Disconnect the brake booster hose and check valve from the brake booster. Position the hose aside.
  3. Remove the manual shaft detent assembly roller. Refer to Control Valve Lower Body and Upper Body Replacement .
1 Engine Sight Shield
Tip:  Remove the engine sight shield by lifting straight up.
2 Supercharger Inlet Duct Assembly
Tip:  Remove the front section of the supercharger inlet duct assembly. Refer to Supercharger Inlet Duct Assembly Replacement .
3 Ignition Coil Assembly Cover
Tip:  Remove the ignition coil assembly cover by lifting straight up, if equipped.
4 Ignition Coil Assembly Bolt (Qty: 2)
NOTE: Refer to Fastener Notice .

Tip: 
  • Do not remove these fasteners if replacing an individual ignition coil. If replacing an individual ignition coil, remove the appropriate bolt or stud.
  • Release the secondary lock, and disconnect the main electrical connector from the coil assembly while the coil assembly partially removed.

Tighten:  10 N.m (89 lb in)

5 Ignition Coil Assembly Stud (Qty: 2)
Tip:  Do not remove these fasteners if replacing an individual ignition coil. If replacing an individual ignition coil, remove the appropriate bolt or stud.

Tighten:  10 N.m (89 lb in)

6 Ignition Coil Assembly
Tip:  Ensure that the spark plug seals are in place during reassembly.
7 Ignition Coil Bolt (Qty: 4)

Tighten:  10 N.m (89 lb in)

8 Ignition Coil (Qty: 4)
Tip: 
  • Disconnect the electrical connector from the ignition coil.
  • Ensure that the spark plug seals are in place during reassembly.
9 Spark Plug Seal (Qty: 4)