Ignition Coil Replacement - Bank 1
| Callout | Component Name |
|---|---|
| 1 | Engine Sight Shield Tip: Remove the engine sight shield by lifting straight up. |
| 2 | Supercharger Inlet Duct Assembly Tip: Remove the front section of the supercharger inlet duct assembly. Refer to Supercharger Inlet Duct Assembly Replacement . |
| 3 | Ignition Coil Assembly Cover Tip: Remove the ignition coil assembly cover by lifting straight up, if equipped. |
| 4 | Ignition Coil Assembly Bolt (Qty: 2)
NOTE:
Refer to Fastener Notice
. Tip:
Tighten: 10 N.m (89 lb in) |
| 5 | Ignition Coil Assembly Stud (Qty: 2) Tip: Do not remove these fasteners if replacing an individual ignition coil. If replacing an individual ignition coil, remove the appropriate bolt or stud. Tighten: 10 N.m (89 lb in) |
| 6 | Ignition Coil Assembly Tip: Ensure that the spark plug seals are in place during reassembly. |
| 7 | Ignition Coil Bolt (Qty: 4) Tighten: 10 N.m (89 lb in) |
| 8 | Ignition Coil (Qty: 4) Tip:
|
| 9 | Spark Plug Seal (Qty: 4) |