LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> XLR V >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 4.4L - Introduction >> Repair Instructions >> Fuel Tank Replacement - Right Side >> Removal Procedure

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (Without CH 48027)  or Fuel Pressure Relief (With CH 48027) .
  3. Drain the fuel tank. Refer to Fuel Tank Draining .
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Remove the right rear tire. Refer to Tire and Wheel Removal and Installation .
  6. Remove the right rear wheelhouse liner panel. Refer to Rear Wheelhouse Liner Panel Replacement .
  7. Remove the evaporative emission (EVAP) canister access cover.
  8. Fig 1: View Of FLVV Hose & EVAP Canister
    GM561895Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the fuel level vent valve (FLVV) hose (1) at the EVAP canister (2). Refer to Plastic Collar Quick Connect Fitting Service .
  10. Disconnect the fuel pump module harness connector.
  11. Remove the crossover tube from the clamp located above the transmission.
  12. Fig 2: Locating Air Inlet Hose
    GM903539Courtesy of GENERAL MOTORS CORP.
  13. Disengage the crossover tube connector position assurance (CPA) retainer by pulling the tab (1) outward and rotate.
  14. IMPORTANT: The crossover tube CPA is released when the latch disengages from the tank connection groove.
    Fig 3: Locating Crossover Tube Collar
    GM903540Courtesy of GENERAL MOTORS CORP.
  15. Rotate crossover tube collar counterclockwise to disengage.
  16. Fig 4: EVAP Crossover Pipe & Tank Crossover Hose
    GM903412Courtesy of GENERAL MOTORS CORP.
  17. Disconnect the crossover tube from the right fuel tank by pulling the tube straight out of the fuel tank connection.
  18. IMPORTANT: Take care not to disturb the internal O-rings in the fuel tank connections.
  19. Disconnect the EVAP crossover pipe (2) quick connect fitting at the right fuel tank. Refer to Plastic Collar Quick Connect Fitting Service .
  20. Cap the EVAP pipe to prevent system contamination.
  21. Fig 5: Fuel Tank Strap Mount, Cover, Screws & Bolts
    GM903428Courtesy of GENERAL MOTORS CORP.
  22. Remove the fuel tank strap mount bolts.
  23. Remove the fuel tank strap from the vehicle.
  24. Fig 6: View Of Fuel Tank - Right
    GM903572Courtesy of GENERAL MOTORS CORP.
  25. Remove the fuel tank.