LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> STS Base, 3.6 V, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> DTC B1517 >> Circuit/System Testing

Circuit/System Testing

B1517 03, B1517 52

  1. If the DTC is history, refer to Charging System Test .
  2. Ignition On, record the voltage at the battery terminals. Observe the scan tool IPM battery positive voltage parameter. The battery terminal and IPM parameter should not differ by more than 2 volts.
    • If not within the specified range, test the B+ circuits of the IPM X3 terminal 1 and X3 terminal 2 to the ground circuit X3 terminal 3.
    • If not within the specified range, test the B+ circuits for a short to ground or an open/high resistance.
  3. If all the circuits test nor mal, replace the IPM.

B1517 52

  1. Verify that DTC B1517 52 is set as current.
  2. Ignition OFF, disconnect the harness connector X3 from the IPM.
  3. Ignition OFF, test for less than 1.0 ohm of resistance between the ground circuit X3 terminal 10 and X3 terminal 3 to ground.
    • If not within the specified range, test the circuits for an open/high resistance.
  4. Ignition On, test the B+ circuits X3 terminal 1 and X3 terminal 2 to ground. The B+ circuits should not differ by more than 2 volts.
    • If not within the specified range, test the circuits for a short to ground or an open/high resistance.
  5. If all circuits test nor mal, replace the IPM.