LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> CTS V >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Exhaust System Replacement (LY7) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Exhaust System Components
    GM786659Courtesy of GENERAL MOTORS CORP.
  1. Install the HO2S to the exhaust system. Refer to Heated Oxygen Sensor Replacement - Bank 1 Sensor 2 and Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 .
  2. Install the muffler rear hangers (2) to the muffler(s).
  3. Fig 2: View Of Exhaust System
    GM1215598Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Flex Decoupler Notice .
  4. With the aid of an assistant, raise the exhaust system into position.
  5. Install the exhaust system (muffler) nuts.
  6. Fig 3: View Of Mufflers & Hanger Rods
    GM1559376Courtesy of GENERAL MOTORS CORP.
  7. Install the mufflers to the muffler rear hangers.
  8. Fig 4: View Of Right Muffler Hanger & Frame Hanger Rod
    GM1559375Courtesy of GENERAL MOTORS CORP.
  9. Install the right muffler front hanger to the frame hanger rod.
  10. Fig 5: View Of Left Muffler Front Hanger & Frame Hanger Rod
    GM1559373Courtesy of GENERAL MOTORS CORP.
  11. Install the left muffler front hanger to the frame hanger rod.
  12. NOTE: Refer to Fastener Notice .
    Fig 6: Identifying Exhaust Pipe Nuts
    GM1224063Courtesy of GENERAL MOTORS CORP.
  13. Install the exhaust pipe nuts.

    Tighten:  Tighten the nuts to 22 N.m (16 lb ft).

  14. Fig 7: Identifying Floor Panel Tunnel Brace
    GM772383Courtesy of GENERAL MOTORS CORP.
  15. Install the floor panel tunnel brace to the floor panel.
  16. Install the floor panel tunnel brace bolts.

    Tighten:  Tighten the floor panel tunnel brace bolts to 25 N.m (18 lb ft).

  17. Fig 8: View Of HO2S Electrical Connector, Sensor 2 (Bank 1 Shown, Bank 2 Similar)
    GM1201222Courtesy of GENERAL MOTORS CORP.
  18. Connect the left and right bank 2 HO2S electrical connectors (bank 1 shown, bank 2 similar).
  19. Install the HO2S wiring harnesses to the transmission case.
  20. Lower the vehicle.