Installation Procedure (4.8L, 5.3L & 6.0L)
- Install the fuel pipe/hose assembly.
- Install the EVAP hose/pipe clips to the brace.
- Install the fuel hose/pipe clips to the frame and brace.
- Remove the caps from the fuel pipes at the fuel tank.
- Connect the fuel feed and return pipes (4) to the fuel tank pipes (3). Refer to REMOVAL & Installation (Plastic Collar) .
- Insert the integral locator tab (3) into the hole in the frame.
- Install the fuel pipe/hose bracket (1) bolt. Tighten the bolt to 12 N.m (106 lb in).
- Install the fuel filter bracket bolts (2). Tighten the bolts to 12 N.m (106 lb in).
- Install the EVAP canister. Refer to EVAP CANISTER .
- If equipped with 4WD, install the fuel hose/pipe clip to the bracket on the transfer case.
- Install the fuel hose/pipe clip to the bracket on the automatic transmission.
- Install the fuel pipe bracket to the bellhousing stud. Tighten the nut to 10 N.m (89 lb in).
- Install the fuel pipe bracket nut (2).
- Reposition and install the front propeller shaft bolts. Refer to PROPELLER SHAFT REPLACEMENT -- FRONT .
- Lower the vehicle.
- Remove the caps from the fuel rail and EVAP pipes.
- Connect the EVAP canister purge tube (3).
- Connect the fuel feed and return pipes (1) at the fuel rail. Refer to REMOVAL & Installation (Plastic Collar) .
- Install the fuel fill cap.
- Connect the negative battery cable. Refer to BATTERY DISCONNECT CAUTION .
-
- Turn the ignition ON, with the engine OFF, for 2 seconds.
- Turn the ignition OFF for 10 seconds.
- Turn the ignition ON, with the engine OFF.
- Inspect for fuel leaks.
NOTE:
Refer to FASTENER NOTICE
.