LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 1992 >> Allante F7/ME9 >> Repair and Diagnosis >> Electrical >> Charging Systems >> Alternator & Regulator >> Diagnostic Tests >> Code B410: Charging System Circuit >> Notes

Code B410: Charging System Circuit: Notes

The generator on this vehicle has fault detection capability built into the regulator. The BCM will supply 12-volts to the regulator over CKT 225, the "L" terminal, and monitor the field voltage of the generator by way of a PWM signal over CKT 23, the "F" terminal. Code B410 will set if the ignition is on, B334 is not set, and the following conditions exist: Engine running, generator enable line "L" terminal is low, generator enable line "L" terminal is high, generator field input is less than 2%, or ignition on, engine not running. The following is in reference to steps in flow chart:

  1. BCM input BI51 displays generator signal voltage as HI or LO depending on the voltage state at the BCM. Normally with key on, engine off, CKT 225 will be pulled LO by the generator, and BI51 will read LO.
  2. This step checks to see if the LO reading is due to CKT 225 or 725, of the generator. If the reading changes from LO to HI when the generator is disconnected, then CKT 225 and the BCM are okay.
  3. This step determines if the fault is due to the BCM or CKT 225.
  4. BCM data value BD51 displays the amount of generator field activity. Under normal conditions, a reading below 5% would indicate a fault in the field circuit or the BCM.
  5. Removing the generator connector will determine if the fault is due to the generator or an open in CKT 225, including the BCM and interface connector.
For flow chart and circuit diagram, refer to illustrations. See Fig 1 and Fig 2 .

Fig 1: Code B410 Flow Chart
G00080781Courtesy of GENERAL MOTORS CORP.
Fig 2: Code B410 Flow Chart Circuit Diagram
G00080782Courtesy of GENERAL MOTORS CORP.