Reed Block Connector Pin Access
Some tests require that voltage and/or resistance measurement be taken at the reed block connector pins. The sensor block side of this connector may be accessed using the following procedure:
- Remove sensor block cover screw and cover. See Fig 1.
- Disengage Orange reed block connector by pulling outward with fingers. See Fig 1, "VIEW A". The reed block connector is marked with the word "PUSH".
- Using a small screwdriver, CAREFULLY disengage the connector locking tab and disengage connector from reed block. See Fig 1, "VIEW B".
- Reed block connector circuits are now accessible for testing. See Fig 1, "VIEW C".