Chart D: Brake Warning Lamp Inoperative During Segment Check: Notes
The red BRAKE warning indicator lamp in the IPC is powered through the IP fuse (fuse No. 1 in the front fuse panel) through CKT 250, and receives 12 volts any time that the ignition switch is in the RUN position. See Fig 1. There are two methods by which the BRAKE indicator lamp can be turned on, including:
- Grounding CKT 852.
- The BCM can turn the BRAKE indicator lamp on by means of the serial data communication link (CKT 800).
- The BRAKE indicator lamp will illuminate any time the ABS/TCS has been disabled by the EBCM. The EBCM will hold the ABS/TCS fault line at ground.