Pump Circuit Operation
The pump relay coil is provided power at key-on through the over-voltage protection relay. The coil ground line (CKT 874) is held at 12 volts at all times with the ignition on. When pump operation is desired, the Pressure Monitoring Module grounds the relay coil at Sensor Block pin 6.
Power is supplied to the pump motor through a fusible link at the front chassis positive junction block. The power circuit from the relay to the pump (CKT 854) passes through the 56-way engine connector which is located under the right side dash near the ECM. The pump motor is grounded on the engine block near the starter motor.
A pump motor monitoring line (CKT 854C) runs from the pump motor relay to EBCM connector pin 31. This circuit is not used by the EBCM and is included in the harness to facilitate testing.