LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 1992 >> Allante F7/ME9 >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Removal & Installation >> Pump/Motor Assembly Components >> Removal

Pump/Motor Assembly Components: Removal

CAUTION: Failure to depressurize hydraulic accumulator prior to performing this operation may result in personal injury and/or damage to painted surfaces.
  1. Depressurize hydraulic accumulator by pumping brake pedal a minimum of 25 times.
  2. Remove air intake duct clamps at air cleaner and throttle body. Remove duct from car.
  3. Disconnect pump motor connector. See Figure.
  4. Remove pressure hose fitting (banjo bolt) . Take care not to drop either of the two washers used to seal the pressure hose fitting to the pump inlet.
  5. Remove pressure and return hose fittings from pump. Position return hose (reservoir to pump) so as to prevent fluid loss from the reservoir.
  6. Loosen pump mounting nut at rear of pump and remove pump from bracket. Inspect mounting insulators for cracks, chafing, cuts or damage. Replace any cut or damaged insulators.