LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 1992 >> Allante F7/ME9 >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Computer Module >> Diagnostic Tests >> DTC L010: Redundant TAILLAMP Relay Failure >> Description

DTC L010: Redundant TAILLAMP Relay Failure: Description

The BCM checks the operation of the redundant relays each ignition cycle after the headlamps are first activated. If the BCM suspects that the tail lamp relay is inoperative, then DTC L010 will be set.

NOTE: When all diagnosis and repairs are completed, clear codes and verify operation.
NOTE: The following numbered steps refer to circled numbers on diagnostic chart. See Fig 1 . For circuit identification, see Fig 2 .
  1. Both redundant relays should be activated with the engine cranking. If the lamp lights while cranking the engine, the relay circuits are working correctly.
  2. This checks for power to the switch portion of the relay.
  3. This checks for power to the relay engagement coil.
  4. This checks the voltage supply to the bulb.
  5. This checks the BCMs ability to ground CKT 961. BCM output BO09 will cycle the ground (CKT 961) only if the headlamp switch is turned on.
Fig 1: DTC L010: Redundant Tail Lamp Relay Failure Flow Chart
G00103599Courtesy of GENERAL MOTORS CORP.
Fig 2: DTC L010: Redundant Tail Lamp Relay Failure Flow Chart Circuit
G00103600Courtesy of GENERAL MOTORS CORP.