LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 1983 >> Seville 5.7 N >> Repair and Diagnosis >> Engine Performance >> System >> DFI Tests W/Codes >> Diagnostic Code Charts >> Code 76 - Cruise Set/Coast Circuit >> Diagnostic Aids

Diagnostic Aids

The Cruise Control set/coast switch sends a 12 volt signal to the ECM when the set/coast switch is depressed.

  1. Code .7.6 indicates that the ECM is not receiving the 12 volt signal from the set/coast switch when it is depressed. Rerun the switch test. To begin the diagnosis, turn the ignition on and the cruise enable switch on. Connect a voltmeter (J-29125) to the P-3 (orange) ECM connector pin F and ground.
  2. If the voltage of pin F reads 12 volts, disconnect the P-3 (orange) ECM connector and measure the voltage on pin F again. If the voltage reads 12 volts, check circuit 917 for a short to voltage. If circuit 917 is OK, replace the set/coast switch. If the voltage on pin F is 0 volts, check for a faulty ECM connector or faulty ECM.
  3. While depressing the set/coast switch, measure the voltage on the P-3 (orange) ECM connector pin F again. If the voltage is 0 volts, check circuit 917 for an open or short to ground and circuit 903 for an open. If circuits 917 and 903 are OK, replace the set/coast switch. If the voltage on pin F is 12 volts, then check for a faulty ECM connector or faulty ECM because it is not processing the 12 volt signal.