Diagnostic Aids
The Cruise Control brake circuit sends a 12 volt signal to the ECM except when the brake is depressed. When the brake is depressed, the switch is opened and the brake signal drops to 0 volts.
- Code .7.1 indicates the brake signal doesn't switch from 12 volts to 0 volts when the brake is applied. With the ignition on backprobe the Cruise Control brake switch connector circuits 904 and 919 with a test light connected to ground on each circuit. If the test light lights on only one side of the switch, then the Cruise Control brake switch does not have continuity and should be replaced if it is properly adjusted.
- If there is a light on both sides of the Cruise Control brake switch, then the switch has continuity. With the ignition on, depress the brake pedal and backprobe the Cruise Control brake switch circuit 919 with a test light to ground. If the test light continues to glow replace the Cruise Control brake switch because it is shorted.
- If the test light does not glow, then the switch is functioning properly. Check circuit 919 for an open. If circuit 919 is OK, check for a faulty ECM connector or faulty ECM because it is not processing a good brake release signal.
- Check the 3 amp cruise fuse. If it is OK, then repair an open in circuit 904.
- If the Cruise Control fuse is not OK, then there is a short circuit to ground in the wiring harness or the ECM. Check circuits 904 and 919 for a short to ground. Engaging the cruise instrument panel switch the set/resume switch, or the resume/ acceleration switch can blow the cruise fuse. This situation would occur if circuits 903, 916, or 917 have a short to ground on them. If the wiring harness is OK and the fuse blows again, check for a faulty ECM connector or faulty ECM because it is internally shorted.