Diagnostic Aids
NOTE:
If this code IS NOT displayed during the third pass of diagnostic codes, it is an intermittent failure and cannot be diagnosed using this procedure. For an intermittent code, refer to NOTE ON INTERMITTENTS.
The ECM supplies a 12 volt signal to pin B, (circuit 427), of the idle speed control motor. When the engine is operating at idle, the throttle linkage closes the throttle switch and pulls circuit 427 to 0 volts through the ground circuit of pin A, circuit 450. When the throttle switch is open, the ISC motor will not try to control idle speed because the driver is controlling the engine speed.
Code 27 indicates that the throttle switch remained open during the previous ignition cycle and has not yet closed during the present ignition cycle. Possible causes are:
- A. A defective throttle switch.
- B. Defective wires, terminals, etc.
- C. An ECM which is unable to process signals properly.
- To begin diagnosis, observe the "throttle switch" status light above the "Lo" button while in diagnostics. If the system is operating properly, the light should come on as the throttle is released. If the light does not come on, refer to the diagnostic decision tree for Code .7.2 since the throttle switch signal is remaining in the "open" mode.
- If the status light comes on, exit diagnostics while in this "closed" throttle mode. Under this condition, the check engine light should go out and Code 27 should remain as an intermittent failure. If the Code 27 remains a hard failure, replace the ECM since it is not processing the signal properly.