Diagnostic Aids
When the ignition is turned on, the ECM energizes the fuel pump relay for 2 seconds which feeds 12 volts to the fuel pump circuit (120). Unless distributor reference pulses are received within this time, the ECM will de-energize the relay so that the fuel pump does not continue to run at ignition on.
Trouble Code 19 indicates that the fuel pump relay circuit continues to have 12 volts on it after the 2 second fuel pressure prime. This voltage is read by the ECM on the fuel pump feedback input (circuit 120). This is also the voltage which is displayed on Engine Data Parameter .1.0. Under the conditions of a Code 19, the "battery voltage" reading will be greater than 11 volts at ignition on (parameter .1.0 reading is normally 0 volts at ignition on). Possible causes of this condition are:
- A. A faulty fuel pump relay.
- B. A faulty oil pressure switch.
- C. Defective wiring, terminals, etc.
- D. An ECM not processing the fuel pump feedback voltage properly or not switching the relay off.
- If the unwanted source of voltage can be eliminated, then self-diagnostics can be used to detect this by displaying engine data parameter .1.0. When the voltage is removed from the circuit, the "battery voltage" reading will drop to 0 volts. Begin eliminating branches of the fuel pump circuit by removing the oil pressure switch connector. If the "battery voltage" reading is now 0, then the oil pressure switch must be replaced because it is closing the switch without receiving oil pressure.
- If the "battery voltage" reading is still greater than 0 volts, another portion of the fuel pump circuit can be eliminated by removing the fuel pump relay. If the "battery voltage" reading is still greater than 0 volts, then circuit 120 and 120E must be inspected for a short to voltage. If the voltage on circuit 120 is greater than 0 volts with the ECM disconnected, the circuit is shorted to voltage. If the voltage is 0, the fault must be in the ECM connector or ECM itself.
- If the "battery voltage" reading is now 0 after removing the fuel pump relay, probe relay socket cavity 5 with a test light to ground. After turning ignition on, the test light should light for 2 seconds and then go out. If the light does go out, replace the relay because it is failing to open.
- If the test light stays on, then either the ECM or the wiring harness is shorted to voltage. If there is voltage on circuit 465 with the ECM disconnected, the circuit is shorted to voltage. If the voltage is 0, check for a faulty ECM connector or faulty ECM.