LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 1983 >> Seville 5.7 N >> Repair and Diagnosis >> Engine Performance >> System >> DFI Tests W/Codes >> Diagnostic Code Charts >> Code 18 - Open Crank Signal Circuit >> Diagnostic Aids

Diagnostic Aids

NOTE: If this code IS NOT displayed during the third pass of diagnostic codes, it is an intermittent failure and cannot be diagnosed using this procedure.

While the engine is cranking, a 12 volt signal will be present in the cranking circuit from the ignition switch to the ECM.

A Code 18 indicates that the 12 volt signal is not present at the ECM while the engine is cranking. Possible causes of this condition are:

  1. Check the 3 amp crank fuse. If it is b]own, check circuit 6 for a short to ground between the fuse and the ECM. If this circuit is OK and the fuse blows again then the short must be in the ECM connector or ECM itself.
  2. If the fuse is OK, check the voltage at the crank fuse while cranking the engine. If the voltage is 0 volts, then an open exists in circuit 6 between the fuse and the ignition switch.
  3. If the fuse has 12 volts on it, then check for voltage on circuit 6 at the ECM while cranking the engine. If 12 volts is measured, then check the pin K terminal for an open before replacing the ECM. If no voltage is measured at the ECM, then repair the open in circuit 6 between the fuse and the ECM.