LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2012 >> Regal Base >> Repair and Diagnosis >> General Information >> OEM General Information >> Vehicle Diagnostic Information - Scan Tool Information - All Systems >> Specifications >> Instrument Cluster Scan Tool Information

Instrument Cluster Scan Tool Information

Instrument Cluster Scan Tool Data Parameters

Parameter Expected Value Description
Operating Conditions:  Ignition ON
Ambient Air Temperature Ambient Temperature The scan tool displays outside temperature in °C or °F.
Battery Voltage 12-14 V The scan tool displays Volts. This is the current battery voltage signal.
Coolant Level Switch Open The scan tool displays either Open, Closed, or Not Available.
Driver Information Center Reset Switch Active/Inactive The scan tool displays Active or Inactive. This is the state of the driver information center reset switch.
Driver Information Center Switch Varies The scan tool displays Volts. This is the current driver information center switch input voltage.
Inactive The scan tool displays either Inactive, Up, Down, or Menu. This is the state of the driver information center switch.
Key in Ignition Status Active/Inactive The scan tool displays Active or Inactive. This is the state of the key in ignition switch.
Engine Speed Varies The scan tool displays the current engine speed in RPM.
Vehicle Speed Varies The scan tool displays the current vehicle speed in MPH or KPH.
Washer Fluid Level Switch Open The scan tool displays either Open, Closed, or Not Available.
Instrument Cluster Scan Tool Output Controls

Output Control Description
All Indicators This function is used to command all the indicators ON or OFF.
CAN Bus Configuration Learn This function is used to Reset the source ID for low speed CAN Bus communications.
Driver Information Center Dimming This function is used to command the dimming of the driver information display to Increase or Decrease by 10%.
Driver Information Center Options This function is used to command the driver information center buttons using the scan tool.
Driver Information Center Segments This function is used to command the driver information center segments ON and OFF.
Instrument Cluster Gauge Sweep This function is used to command the gauges to sweep from minimum to maximum.