LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure Super >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Steering Linkage Outer Tie Rod Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Outer Tie Rod Assembly To Inner Tie Rod Assembly
    GM297355Courtesy of GENERAL MOTORS CORP.
  1. Install the outer tie rod assembly (3) to the inner tie rod assembly (1). Do NOT tighten the jam nut (2).
  2. Fig 2: View Of Outer Tie Rod & Steering Knuckle
    GM297628Courtesy of GENERAL MOTORS CORP.
  3. Install the outer tie rod assembly (2) to the steering knuckle (1).
  4. Fig 3: Identifying Outer Tie Rod & Retaining Nut
    GM575833Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  5. Install the prevailing torque nut (2) to the outer tie rod assembly (1).

    Tighten:  Tighten the nut to 30 N.m plus 120 degrees (22 lb ft plus 120 degrees). Inspect to ensure that 21/2-41/2 threads are visible above the nylon washer.

  6. Install tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle.
  8. Perform a front end alignment. Refer to Wheel Alignment Measurement .