LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Rendezvous CXL >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Inlet Pipe Replacement >> Installation Procedure

Installation Procedure

  1. Position the power steering pump inlet pipe/hose to the vehicle.
  2. Fig 1: Power Steering Pump Inlet & Steering Cooler Pipes/Hoses
    GM1798675Courtesy of GENERAL MOTORS CORP.
  3. Compress the clamp (1) and connect the power steering pump inlet pipe/hose (2) to the power steering cooler pipe/hose (3).
  4. Fig 2: Power Steering Pump Inlet Pipe/Hose
    GM1803724Courtesy of GENERAL MOTORS CORP.
  5. Compress the clamp (1) and connect the power steering pump inlet pipe/hose (2) to the power steering reservoir (3).
  6. NOTE: Refer to Fastener Notice .
    Fig 3: Power Steering Pump Inlet Pipe/Hose Routing Clip
    GM1803725Courtesy of GENERAL MOTORS CORP.
  7. Position the power steering pump inlet pipe/hose routing clip (2) and install the bolt (1).

    Tighten:  Tighten the power steering pump inlet routing clip bolt to 10 N.m (89 lb in).

  8. Install the right front tire and wheel assembly. Refer to Lifting and Jacking the Vehicle .
  9. Lower the vehicle.
  10. Remove the generator bracket. Refer to Generator Bracket Replacement (RPO LX9) .
  11. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
  12. Install the drive belt. Refer to Drive Belt Replacement .
  13. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  14. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .